News Center

Roller Shutter Tubular Motor Manufacturers Introduces The Installation Method Of Electric Curtains


Roller Shutter Tubular Motor Manufacturers introduces t […]

Roller Shutter Tubular Motor Manufacturers introduces the installation method of electric curtains:


1. It is best to install the socket in an inconspicuous place: it is used to provide power to the electric curtains. The socket may have other electrical appliances near the location where it is placed, at least 5 holes. In this case, if you don't like the electric curtains and need to replace them in a few years, this circuit can also be used for other purposes. Sometimes it can also be used as a power source for an air conditioner. Of course, in this case, the diameter of the cloth should be larger wire.


2. The choice of socket location: it is best to hang the curtain on the corner wall adjacent to the wall. This is done for safety. If the curtain blocks the tea seat, it is easy to cause a safety hazard when there is a problem with the circuit. 3. It is not recommended to install it above: instead, I prefer to install it below. When needed, other electrical appliances or plug-in boards can be connected, that is, it will not be unsightly, and it can also be used for water and electricity changes.


Create budget savings. Objectively speaking, compared with the decoration value of your entire room, electric curtains are only a small part. There is no need to set up a plugboard at a high place for this value. If your room cover is arranged in the future, the possibility of using it higher than the plugboard is too small.